Job Description
- Participate in digital IP development/evaluation and SOC integration;
- Protocol specification study, signal processing algorithm analysis, design prototyping and IC implementation;
- Working full ASIC design cycle from design, RTL coding, verification, synthesis, timing closure

職務說明:
1.Bluetooth SoC Firmware/Profile Development
2.Improve current architecture of firmware for high performance
3.Understand Bluetooth link management, and protocol
4.Understand Bluetooth profiles and operations
5.Bluetooth Embedded system integration and verification
6.IOT 相關產品開發

任職條件:
1. 良好的團隊精神, 工作積極, 為人踏實
2. 抗壓性高、獨立自主、溝通協調能力
3. 在IC設計產業10年經驗者
4. 藍芽 、MP3、Mobile Storage (MS) 、MCU產品經驗者尤佳

職務說明:
1.藍牙相關程式開發及撰寫

任職條件:
1.藍牙 stack, profile, 驅動程式與系統應用開發經驗
2.熟悉 embedded system
3.熟悉 Linux, Android 或其他 RTOS
4.三年以上 device driver 的移植或開發
5.三年以上 software/firmware的工作經驗
6.熟悉 Bluetooth, WIFI 或 Audio 者佳

職務說明:
1.SSD演算法開發與韌體程式撰寫

任職條件:
1.熟悉NAND flash管理演算法（FTL）和系統設計。
2.熟悉SATA或PCIe介 面協定。
3.有SSD firmware開發經驗，其它SD3.0，eMMC, UFS經驗也可。
4.有開發 SSD 開卡 Windows tools 或 FW 經驗。
5.電機電子工程相關,資訊工程相關,其他數學及電算機科學相關

Job Description:
1. Design of embedded analog/mixed-signal IC circuits for 8-bit/32-bit Microcontroller (MCU) or Systems-on-a-Chip (SoC);
2.The job includes detailed circuit design and analysis, schematic capture and layout, circuit simulation, behavior modeling (C++, Matlab, Verilog), IC testing and debugging;

Requirement:
1. Bachelor or Master in Electronic Engineering with at least 3 years relevant working experience;
2. Knowledge of engineering fundamentals especially in deep submicron CMOS technologies;
3. Hands-on IC layout skills and IC measurement skills;
4. Familiar with datacom standards such as MIPI, USB, PCIe, SATA/SAS, or 10G Ethernet a plus.
5. Familiar in any of the following analog design areas:
(A) RX: CTLE, DFE, CDR
(B) TX: Pre-emphasis, driver
(C) PLL, Frequency Synthesizer

任職條件:
1.熟悉COMS Sensor影像處理演算法，或晶片級設計，有豐富的ISP工作經驗。
2.熟悉ISP硬體架構，瞭解ISP內部模組的處理和流水，以及各個演算法點的實現和優化；
3.tunning方面，對sensor參數，3A調試，色彩調整有豐富經驗；